（School of Mechanical and Electrical Engineering, Wuhan Institute of Technology, Wuhan 430205, China）
Abstract: In order to investigate the effect of different flow field structures on the performance of proton exchange membrane fuel cell(PEMFC), a novel bionic flow field based on the improved capillary structure of human lungs was designed. In this paper, computational fluid dynamics software Fluent was used to carry out numerical simulation for the PEMFC in bionic flow field, parallel flow field, and single snake flow field respectively. The polarization curves, the pressure drop, the distribution of gas concentration and the distribution of the current density of three PEMFCs were compared, and the effects of relative humidity of cathode and anode on the performance of novel bionic flow field PEMFC were explored. The results showed that the distribution of hydrogen, oxygen and water in the bionic flow field is most uniform,the pressure drop value of the cathode channel is smallest, and the current density on the cathode catalytic layer is largest. At high voltage,with the increasing of cathode and anode humidity, the current density increases, resulting in improved cell performance, and the effect of anode gas humidity on cell performance is greater than that of cathode gas humidity. At low voltage, with the increasing of cathode and anode humidity, the current density decreases, resulting in decreased cell performance, and the effect of cathode gas humidity on cell performance is greater than that of anode gas humidity.
Key words: proton exchange membrane fuel cell; numerical simulation; relative humidity of cathode and anode; flow field structure
參考文獻
[1] 衣寶廉. 燃料電池——原理·技術·應用[M] . 北京：化工工業出版社，2003.
[2] JO J H, KIM W T.Numerical simulation of water droplet dynamics in a right angle gas channel of a polymer electrolyte membrane fuel cell[J].International Journal of Hydrogen Energy，2015，40(26) ：8368-8383.
[3] HU Hao, XU Xiaoming, MEI Nan, et al.Numerical study on the performance of fuel cell with wavy flow field plate[J].Ionics，2020，26(12) ：1-9.
[4] CHEN Xi, CHEN Yao, LIU Qian, et al.Performance study on a stepped flow field design for bipolar plate in PEMFC[J].Energy Reports，2021，7(35) ：336-347.
[5] 張貝貝，李陪超. 流道結構對質子交換膜燃料電池的影響[J]. 農業裝備與車輛工程，2021，59(10) ：21-26.
[6] 陳磊，郭朋彥，張瑞珠，等. 質子交換膜燃料電池流道尺寸對電池性能的影響[J] . 河南科技，2018(1) ：141-142.
[7] 汪龍飛，楊俠，嚴智遠，等. 流場結構對氫燃料電池性能的影響[J] . 武漢工程大學學報，2022，44(4) ：445-449.
[8] 樊文選. 基于玉米葉脈結構的 PEMFC 雙極板主流場水管理研究[D]. 吉林：吉林大學，2021.
[9] KAHRAMAN H, ORHAN M F.Flow field bipolar plates in a proton exchange membrane fuel cell：Analysis & modeling[J].Energy Conversionoe Management，2017，133 ：363-384.
[10] 高鵬然. 氫燃料電池應用進展研究[J] . 石化技術，2020，27(6) ：115-116.
[11] IONESCU V.Simulating the effect of gas channel geometry on PEM fuel cell performance by finite element method[J].Procedia Technology，2016，22 ：713-719.
[12] 劉康杰，陳濤，劉士華，等. 進氣方式對陽極閉端 PEMFC 溫度分布及性能影響[J] . 電源技術，2020，44(12) ：1755-1758.
[13] BOYD B,HOOMAN K.Air-cooled micro-porous heat exchangers for thermal management of fuel cells[J].International Communications in Heat & Mass Transfer，2012，39(3) ：363-367.
