特高壓雙電壓回路合成試驗方法研究
那虎1，肖承仟2，張建新1，楊葆鑫1，邢文奇1，趙新陽1，李陽1，張高潮1
（1 河南省高壓電器研究所有限公司，河南 平頂山 467001；2 國網河南省電力公司平頂山供電公司，河南 平頂山 467000）
摘 要：合成試驗是高壓交流斷路器的重要檢驗檢測方法，當電壓等級超過1 100 kV時，需采用一種適用于高壓特高壓的其它合成試驗方法——雙電壓回路的合成試驗方法，分析了雙電壓回路合成試驗的原理、計算方法、等價性評估、檢驗檢測結果、試驗實施等問題。重點解決電壓等級較高時的雙電壓回路合成試驗的分析計算及實施方法，并采用該方法對550 kV/63 kA斷路器開展T100s整極試驗，檢驗檢測結果驗證了分析計算和實施方法的正確性、合理性。指出：對于額定電壓≥800 kV等級的斷路器，采用雙電壓回路合成試驗的方法進行考核是正確的和有利的。但必須滿足兩個特定要求：(1) 電壓分配系數Kf為[0.5，0.65]；(2) 對于電壓等級≥800 kV等級的斷路器，工頻恢復電壓試驗公差須修正為[-5%，+10%]。
關鍵詞：高壓交流斷路器；雙邊加壓；單邊加壓；雙電壓回路；合成試驗；電壓分配系數
中圖分類號：TM762.1+4 文獻標識碼：A 文章編號：1007-3175(2020)01-0008-09
Study of Duplicate Voltage Circuit for UHV Synthetic Test Method
NA Hu1, XIAO Cheng-qian2, ZHANG Jian-xin1, YANG Bao-xin1, XING Wen-qi1, ZHAO Xin-yang1, LI Yang1, ZHANG Gao-chao1
（1 Henan High Voltage Apparatus Research Institute Co.,Ltd, Pingdingshan 467001, China;
2 State Grid Corporation-Electric Power of Pingdingshan, Pingdingshan 467000, China）
Abstract: The synthetic test is an important inspection and detection method of high-voltage alternating current circuit-breaker.When the voltage level was up to 1 100 kV, a kind of other synthetic test method suitable for high-voltage UHV, the synthetic test of duplicate voltage circuit, was adopted.This paper analyzed the principle, computing method, equivalency assessment, inspection and detection results and test implement etc problems of synthetic test of duplicate voltage circuit, especially for the analysis calculation and implement method of synthetic test of duplicate voltage circuit when the voltage level was higher.With this method, the 550 kV/63 kA circuit-breakers were carried out T100s whole-pole tests.The inspection and detection results verified the validity and rationality of analysis calculation and implement method.It is pointed out that for circuit-breakers of rated voltage ≥800 kV, adopting the synthetic test method of duplicate voltage circuit is appropriate and favorable, but there are two necessary requirements: (1) Voltage allocation factor Kf should be [0.5,0.65], (2) Test tolerance of power frequency recovery voltage must be amended to [-5%,+10%].
Key words: high-voltage alternating current circuit-breaker; double side applied voltage; single side applied voltage; duplicate voltage circuit; synthetic test; voltage allocation factor
參考文獻
[1] 米爾薩德· 卡普塔諾維克. 高壓斷路器——理論、設計與試驗方法[M]. 王建華，閆靜，譯. 北京：機械工業出版社，2015.
[2] RENE Peter Paul Smeets, SANDER Kuivenhoven, PIET Knol, et al.1 100 kV/1 200 kV 斷路器大功率試驗[J]. 南方電網技術，2009，3(6)：1-8.
[3] KUROZAWA Y, TAKAHASHI T, SAITO K, et al. Four-parameter transient recovery voltage circuits appropriate for test extra high voltage circuit breakers[C]//CIGRE，1989.
[4] SHENG B L, SLUIS Lou van der.A new synthetic test circuit for ultra-high-voltage circuit breakers[J].IEEE Transactions on Power Delivery，1997，12(4)：1514-1519.
[5] DU Wei, YAO Sili, LI Peng, et al.Study on High-Power Test Techniques for UHV Circuit Breaker[C]//IEC/CIGRE UHV Symposium，2007.
[6] International Electrotechnical Commission. High-voltage switchgear and controlgear—Part100：Alternating-current circuit-breakers：IEC 62271-100( Edition 2.1) [S]. Geneva：International Electrotechnical Commission Publication，2012：9-49.
[7] 裴振江，姚斯立，何俊佳，等. 一種新的特高壓斷路器合成試驗回路[J]. 中國電機工程學報，2007，27(33)：65-69.
[8] 李剛，孫梅，程茵. 一種新的合成試驗回路[J]. 高壓電器，2009，45(6)：136-139.
[9] 王仁甫. 斷流容量試驗回路中四參數瞬態恢復電壓的計算[J]. 高壓電器，1985(4)：3-18.
[10] 王仁甫. 斷流容量試驗回路中二參數瞬態恢復電壓的分析及回路參數的計算[J]. 高壓電器，1983(3)：10-22.
[11] SLUIS Lou van der, SHENG B L.The influence of the arc voltage in synthetic test circuits[J]. IEEE Transactions on Power Delivery，1995，10(1)：274-279.
[12] SLUIS Lou van der, RUTGERS W R, KORMAN C G A. A physical arc model for the simulation of current zero behavior of high-voltage circuit breakers[J].IEEE Transactions on Power Delivery，1992，7(2)：1016-1022.
